INSTRUCTION MANUAL BUILT-IN WINE COOLER MODEL: TAHJ408 E-mail: support@tazpi.com Phone: (252)772-1994 Read this manual and follow all safety rules and operating instructions before first use of this wine cooler.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS 3 PRODUCT DIAGRAM 6 INSTALLATION INSTRUCTIONS 7 Before Using Your Wine Cooler 7 To Install Stainless Steel Handle 7 To Install Your Wine Cooler 8 OPERATION INSTRUCTIONS 10 Controls 10 Recommended Temperature Settings 10 Storage 11 Door Lock 11 Shelves 11 To Remove a Sliding Shelf 12 CARE & MAINTENANCE 12 Cleaning Your Wine Cooler 12 Power Failure 13 Vacation Time 13 Moving Your Wine Cooler 13 Energy Saving Tips 13 Charcoa
IMPORTANT SAFETY INSTRUCTIONS Your safety and the safety of others are very important. This wine cooler complies with the applicable safety requirements and is safe for daily use. However, basic safety precautions should always be followed when using an electrical appliance, to reduce the risk of fire, electric shock, and personal injury. Plug into its own individual electrical outlet with a voltage rating that matches the rating label on the cooler (115/120V AC only, 60Hz, 10A).
1.This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 2. Children should be supervised to ensure that they do not play with the appliance. 3.
– If the refrigerating appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent mould developing within the appliance. Do not use this wine cooler for other than its intended purpose. For indoor, household use only. Move this wine cooler by 2 people. Failure to do so can result in injury. Place this wine cooler in a well-ventilated area with temperatures above 15°C (60°F) and below 32°C (90°F).
FLAMMABLE REFRIGERANT GAS DANGER - Risk of fire or explosion. Flammable refrigerant used. DO NOT use mechanical devices to defrost refrigerator. DO NOT puncture refrigerant tubing. DANGER - Risk of fire or explosion. Flammable refrigerant used. To be repaired only by trained service personnel. DO NOT puncture refrigerant tubing. CAUTION - Risk of fire or explosion. Flammable refrigerant used. Consult repair manual / owner’s guide before attempting to service this product.
1 Control Panel 5 Top Hinge 2 Shelves 6 Glass Door with Handle 3 Exhaust Window 7 Safety Child Lock 4 Leveling Legs INSTALLATION INSTRUCTIONS Before Using Your Wine Cooler Remove the exterior and interior packaging.
screwdriver until the handles secure tightly against the door frame, as Illustration #2. (Do NOT over tighten as this will cause damage to the handle assembly). 3) Replace the door gasket to its original position. Note: This wine cooler includes stainless steel handles that are not required to operate this wine cooler.
properly. It is not advisable to install this cooler in moist areas or directly adjacent to a kitchen sink, as moisture could cause premature corrosion to the components of your new cooler. It is recommended you install the wine cooler in a place with temperatures above 60°F (15°C) and below 90°F (32°C), and humidity is under 60%. If the ambient temperature is above or below recommended temperatures, the performance of the cooler may be affected.
OPERATION INSTRUCTIONS Controls After plugging the wine cooler into a wall outlet, the cooler would turn on automatically and the LCD screen would show the temperature inside of the cooler. After setting your desired serving temperature, allow the cooler to cool down for 3 to 4 hours before placing wine bottles in the wine cooler. Temperature setting range：5-18ºC (40-65ºF) Press once to turn the interior light ON or OFF.
Wine Varietal °F °C Rose and Sparkling Wines 41°F-46ºF 5°C-8ºC Dry/White Wines 48°F-53ºF 9°C-12ºC Red Wines 59°F-65ºF 14°C-18ºC Storage This wine cooler is designed to store standard Bordeaux 750 ml wine bottles. Many bottles differ in size and dimensions. As such, the actual number of bottles you may be able to store may vary. Storing large and/or oddly shaped bottles (including champagne and sparkling wine bottles) will decrease the capacity of your wine cooler.
To Remove a Sliding Shelf 1. Remove all bottles from the shelf. 2. Pull the shelf out as far as it will go. 3. Adjust the lever on each side of the shelf, as shown below (UP on the left, DOWN on the right) and at the same time, pull the shelf out completely. CARE & MAINTENANCE Cleaning Your Wine Cooler IMPORTANT: Always unplug the cooler before cleaning or performing maintenance. Never use harsh cleansers or scouring pads to clean any part of the cooler.
Power failure Most power failures are corrected within a few hours and should not affect the temperature of your wine cooler. If the power is off for an extended period of time, proper steps should be taken to protect your contents. Vacation Time Leave the wine cooler operating during vacations of less than three weeks. For periods longer than this, turn the wine cooler off and leave the door slightly ajar to prevent odor from building inside the wine cooler.
Charcoal filtration system Your wine is a living object that breathes through the cork of its bottle. In order to preserve the quality and taste of your fine wines, they must be stored at the ideal temperature and ambient conditions. Your wine cooler is equipped with an active charcoal filtration system to ensure air purity, cooling efficiency, and to maintain an odor free cabinet for the storage of your fine wines.
TROUBLESHOOTING GUIDE PROBLEM The wine cooler does not run. The wine cooler is not cold enough. The compressor turns on and off frequently. POSSIBLE CAUSE SOLUTION The wine cooler may not be plugged in, or plug may be loose. Ensure the wine cooler has been plugged in properly. The wine cooler is turned off. Press House fuse blown or tripped circuit breaker. Check/replace fuse. Reset circuit breaker. External environment may require a higher setting. Set a colder setting.
PROBLEM The light does not work. Vibrations. The cooler seems to make too much noise. The door will not close properly. Moisture build up on interior or exterior of the wine cooler. Error Code: E1-E2-E3-E4-E7-E8 POSSIBLE CAUSE SOLUTION Not plugged in. Plug the cooler in. The circuit breaker tripped or a blown fuse. Check the breaker and/or fuses. The light button is “OFF”. Press The cooler is not leveled. Check to assure that the cooler is level. The bottles are vibrating.
Warranty Terms Warranty Period 1. Customers are entitled to replacement or free repair service in case of quality defect(s) found in the product within 15 days upon receipt of the product. 2. Customers are entitled to free repair service from TAZPI for any product proven defective in material or workmanship that results in product failure during normal consumer usage and conditions within the valid warranty period, which is 12 months counting from the date of selling.
