Use and Care Manual

screwdriver until the handles secure tightly against the door frame, as Illustration #2. (Do NOT

over tighten as this will cause damage to the handle assembly).

3) Replace the door gasket to its original position.

Note: This wine cooler includes stainless steel handles that are not required to operate this wine

cooler. If you choose not to use the handle supplied, simply follow step 1 to access the

pre-installed screws and remove them and then place 2 decorative plugs (NOT included) into the

two holes separately. Continue on to step 3 to replace the door gasket to its original position.

Illustration #1 Illustration #2

To Install Your Wine Cooler

 This wine cooler is designed for free standing or built-in (fully recessed) installation.

 Place your wine cooler on a solid and level floor that is strong enough to support it when it is

fully loaded. This will ensure a vibration-free and noise-free operation. Adjust the leveling

legs in and out to stabilize the cooler horizontally. If the legs are not properly adjusted, the

cooler may be unstable and result in excess noise or vibration.

 Locate the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator,

etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical

consumption. Extremely cold ambient temperatures may also cause the cooler not to perform

Gasket

Screw

Screw Driver

Handle