Users Manual



Connecting CROSSFIRE Diversity receiver

The compact receiver unit fits everything from small multirotors to very large airplanes. The receiver is
capable up to 8.4V and needs at least 4.5V input voltage. This can be applied to any of the eight servo
headers, e.g. a servo cable from a ESC with BEC, or a stand-alone BEC, with a suitable amperage rating -
min. 1A recommended. Make sure that adequate power is available by letting the model run for a few
minutes with servos connected, and check your BEC temperature.
If you want to connect additional TBS products to you setup, e.g. CORE PRO, CURRENT SENSOR, BLACKBOX
and GPS, we are providing a 3-way BST splitter adapter to connect everything together.
The receiver servo header pin-polarity is standard and shown in the photo below. R/C signal for the flight
controller, servos or other equipment is connected to the white cable. All the power pins are
reverse-polarity protected.
 



14