Users Manual
Note that the squared-pin has change in later revisions, but the pinout is still the same.
Binding
Binding the transmitter and receiver is super simple.
1. Just power up the TBS CROSSFIRE transmitter
2. On the standard transmitter, enter the configuration menu by pressing and holding the joystick for
3 seconds, select “General” and “Binding” - a message “Binding” will start blinking, waiting for the
receiver. On the micro transmitter, a short press on the button will initiate binding mode. For the
TBS Tango, you can use the “Devices” menu and navigate to “Crossfire TX/ Binding”. For OpenTX,
you need to do the same just in the LUA script.
3. Now, power up the receiver, press and release the “BIND” button on the receiver to initiate
binding. On the receiver is a timeout of one minute for after power up to enter bind mode. If the
status LED will start blinking slowly you the receiver has switched successfully to bind mode.
Within a few seconds the process will finish with a “Binding complete” message. The receiver has now
stored the unique serial number of that particular transmitter. If the transmitter starts to flash blue this
17