Manual

COMPARE

The reason for adding this Compare function is that it can be difficult to estimate what the EQ and/or the Dynamics actually are doing to

the sound of your material. Due to the extra gain of the Normalizer and the Compressor, in-circuit and out-of-circuit, comparisons are

often difficult to make using the BYPASS key.

This is why we made it possible to reduce the level of your processed setting when comparing it with the bypassed sound. You can even

Compare with the last recalled preset.

Press the COMPARE key and use the ADJUST wheel to lower the level of your setting.

Then use the PARAMETER keys to compare the three different sounds:

- The original

- Your edited preset

- The bypassed signal

Listen to original preset

If you place cursor here, you will hear

the original preset.

Listen to your edited sound

If you place the cursor here, you will

hear the edited sound.

Use the ADJUST wheel to adjust this

level for better comparison with the

Bypassed signal.

Bypassed signal

Same function as the BYPASS key.