Manual Addendum

4
Killdry - Utility menu
Range: On/off
When using G-System in a parallel setup or in a parallel
loop, the Kill Dry function comes in handy. With Kill Dry
activated, no direct signal is passed to the outputs of
G-System.
A few comments regarding the Kill Dry function and a
parallel setup:
First of all:
• In such a setup, we recommend using the Parallel
routing.
• When the Kill Dry parameter is set to “On”, no clean
signal is passed to the outputs, and the “Mix”
parameter changes to “Wet” in all algorithms.
You should also be aware that the way the signal is
routed in a parallel loop is similar to the signal path
within a mixer. The signal is split: One part runs
unprocessed to the output and never passes the
actual effects processor. The other part of the signal
is processed within G-System and summed with the
unprocessed signal. Therefore, you will not get to
enjoy the benefits from all effects when running a
parallel setup. This goes especially for level-based
effects such as Tremolo and Panner, but the
Chorus/Flanger Phaser, Vibrato and Pitch blocks.
MISC. - KILL DRY SERIAL 2 ROUTING
Serial 2 Routing
The Serial 2 routing is a variation of the Serial routing
that allows you to apply modulation effects to the delay
repeats only.
The advantage of the Serial 2 routing is that with
longer delay times, you can use rather extreme
modulation effects without blurring the dry signal.