Algorithm Manual Revision 4

Reverb8
English Manual – Updated 2018-02-28 37
Mute Group 1 & Mute Group 2 button
Use the Mute Group 1 & Mute Group 2 buttons
to temporarily mute all Reverb Channels as-
signed to Groups 1 and 2.
Pre Delay section
Pre Delay Group 1 & Pre Delay Group 2
Range: 0 to 150 ms
Use the Pre Delay Group 1 & Pre Delay Group 2
parameters to apply a pre-delay to the Reverb
Channels assigned to Groups 1 and 2.
Please note that in addition to these Pre Delay
Group parameters, each Reverb Channel can be
delayed individually using the eight Ch. param-
eters in the Delay Trim section of the Trim page.
Zero Group 1 & Zero Group 2 buttons
Use the Zero Group 1 & Zero Group 2 buttons
to temporarily remove the delay from the Reverb
Channels assigned to Groups 1 and 2.
Reverb 8 algorithm – Grid page
Fig12. Reverb 8 algorithm – Grid page
For a description of the actual Grid and how to
use it, please see the previous section “Using
the Grid” (page 34).
Reset button
To reset the position of the green selector dot for
the currently selected parameter to Zero (center
of grid), click the Reset button.
Decay
Range: 0.1 to 20 s
Use the Decay parameter to define the basic de-
cay time of Reverb 8. This is defined as the time
it takes the Reverb to decay 60dB. The Decay
times for all eight Reverb channels as defined by
the position of the green dot on the Grid page
refer to the setting of this parameter. This means
that when the Decay parameter is selected and
the green dot is centered in the Grid, the Reverb
Decay time for all eight Channels will be the val-
ue shown for this parameter.