Algorithm Manual Revision 4

Reverb8
42 System 6000 MKII Algorithms – Firmware version 6.5.0
Rev page – Reverb Color section
Lo Damp
Range: -18 to 0dB
Reverb8 is equipped with an adjustable low-cut
filter that allows you to remove low frequencies
from the Reverb. Use the Lo Damp parameter to
set the amount of cut.
Lo Freq
Range: 20 to 200Hz
Use the Lo Freq parameter to set the filter fre-
quency for Reverb 8’s low-cut filter .
Hi Soften
Range: -50 to 50
Hi Soften is a special filter used to “soften” the
high frequencies of Reverb8. This is not a simple
high-cut filter, but a complex set of filters work-
ing together to remove those frequencies that
make a reverb sound “brittle” or harsh.
Lo Mult.
Range: 0.01 to 2.5
Use the Lo Mult. parameter to define a multi-
plier for the frequencies below the Lo X Over
frequency.
For example: If the main Decay parameter on the
Grid page is set to two seconds, and the Lo Mult.
parameter is set to 1.5, frequencies below the Lo
Xover frequency will decay for three seconds.
Lo Mid Mult.
Range: 0.01 to 2.5
Use the Lo Mid Mult. parameter to define a mul-
tiplier for the frequencies below the Mid X Over
frequency.
Hi Mid Mult.
Range: 0.01 to 2.5
Use the Hi Mid Mult. parameter to define a mul-
tiplier for the frequencies below the Mid X Over
frequency.
Hi Mult.
Range: 0.01 to 2.5
Use the Hi Mid Mult. parameter to define a mul-
tiplier for the frequencies above the Mid X Over
frequency.
Lo X Over
Range: 20 to 500 Hz
Use the Lo X Over parameter to define the cross-
over frequency from the Low Frequency band to
the Low Mid Frequency band.
Mid X Over
Range: 200 Hz to 2 kHz
Use the Mid X Over parameter to define the
crossover frequency from the Low Mid Frequen-
cy band to the High Mid Frequency band.
Hi X Over
Range: 689 Hz to 20 kHz
Use the Hi X Over parameter to define the cross-
over frequency from the High Mid Frequency
band to the High Frequency band.