Manual

6. Quick Setup
This guide applies for a simple setup as illustrated below.
Requirements for this setup are:
• A Reverb TwentyFour.
• A CAT5 Ethernet cable.
• A computer equipped with an Ethernet adapter, running Microsoft Windows
or Mac OS X and the latest version of TC Icon software.
Laptop
Ethernet
Ethernet
Power Cable
Procedure:
• Unpack the Reverb TwentyFour and install it in a stable, dry, and
well-ventilated space.
• Connect the Reverb TwentyFour and your computer using an Ethernet cable.
• Power up your computer and the Reverb TwentyFour.
• If you have not already done so, download and install the latest version of
the TC Icon software editor onto your computer. (See page 5 for details)
• Launch the TC Icon software on your computer.
The following screen will appear:
• Click “Assign”. The network is scanned, and all connected and operational
devices will be listed on the next screen:
• Select the device you wish to access.
• To have TC Icon detect more devices and assign them to one of up to eight
slots, see “Assigning devices to the available slots” on page 26.
• If you cannot access the Reverb TwentyFour, please refer to “Networking
basics and troubleshooting” on page 12.
Operating multiple computers and/or TC Icon devices in
one network
In a more complex setup with multiple TC Icon hardware remote controls and/
or several networked computers running TC Icon software, each of these TC Icon
units and computers can be used to connect to TC HD devices (System 6000 MKII,
Reverb TwentyFour, Loudness Pilot, UpCon) on this network.
If your setup contains multiple TC HD devices, you should name these devices
unambiguously so you don’t accidentally edit the settings of the wrong device.
Scanning / rescanning a network for devices
The scenario described above covers the rst time you boot up your system or
when no connected units are assigned.
You should scan the network again when you do any of the following:
• You make changes to your setup.
• When devices are powered up or down, or.
• If there are connection errors, these may not be detected immediately.
To scan a network for devices:
• In the TC Icon software, go to Setup/ Devices.
• Click the Detect button.
For further information, see “Devices page” on page 26.
That’s it – you are now ready to congure and operate your Reverb TwentyFour.
14 REVERB TWENTYFOUR Owner’s Manual