Manual

7. 5 System/ Setup/ Net
Go to Frame/System/Setup/Net
Use this page to:
• Show the network parameters and network name of the device.
• Reboot the device.
This page shows details of the various network parameters. These can be altered
if required, by clicking on the numbers and entering new numbers.
• Network Identier – this shows the device name, the Reverb TwentyFour.
• IP Address – The TCP/IP address of each device connected to a network has
to be unique. An IP address consists of four decimal numbers (ranging from
0 to 255) separated by dots, e.g. 192.168.1.1 The rst three numbers (e.g.
“192.168.1”) must be the same for each unit – but the remaining number
has to be unique in the subnet, i.e., no two units in the subnet can have
the same last number. The default IP address of each Reverb TwentyFour is
192.168.1.[nn], where [nn] is identical to the last two digits in the Reverb
TwentyFour’s serial number (shown on a label on the rear panel of the
device, or in the system/setup/version page). This way, multiple Reverb
TwentyFours can be setup directly out of the box without having to change
their IP numbers.
• IP Subnet Mask – The subnet mask is a number that denes a “group” of
computers (or other devices) connected to a network. All units in this group
must have the same subnet mask. The default subnet mask of each Reverb
TwentyFour is 255.255.255.0.
• IP Gateway – The default value is 0.0.0.0 and is not usually changed.
• Reboot Device – press this circular button to reboot the Reverb TwentyFour
on the network. This should be done if you have made any changes to the
settings above, or any physical changes to the external network
or connections.
7.6 System/ Setup/ Update
Go to Frame/System/Setup/Update.
Use this page to:
• Enter the le location of the latest downloaded rmware le.
• Find the downloaded rmware le.
• Install the new rmware.
To update the rmware, please proceed as follows:
• Please go to www.tcelectronic.com and locate the Reverb TwentyFour
section. Alternatively, you can visit the support\software section and locate
the available software downloads for the Reverb TwentyFour unit.
• Download the Reverb TwentyFour rmware if it is newer than the version
shown in the System/Setup/Version page.
• If the le is zipped, please unzip it and make a note of its le location
on your computer.
• In the "Common Software Update Folder" area of the System/Setup/Update
page above, enter the folder where you stored the downloaded rmware
le, and press enter. The available le should now appear in the area below.
• Check that the lename is correct, and then press the circular “Update SW”
button at the right. Be careful, as there may be more than one rmware le
shown, so make sure you get the latest version.
• The rmware should now be downloaded onto the Reverb TwentyFour, and
a conrmation will be shown on-screen when this is completed.
19 REVERB TWENTYFOUR Owner’s Manual