Manual

9. TC Icon Setup
This chapter covers screens and parameters of the TC Icon software not directly
related to the day-to-day operation of your Reverb TwentyFour.
Accessing the Icon Setup pages.
• Switch the TC Icon software to Base mode by clicking the Icon symbol in the
upper left corner of the window.
In Base Mode, you will see the Select, Auto and Setup tabs on the upper edge of
the TC Icon window.
• Select the Setup tab.
• Select one of the pages described below :
Info, Devices, Security, UI, and Color.
9.1 Info page
On this page, the version number of the currently installed TC Icon software is
displayed. To update the TC Icon software, please refer to the “TC Icon software
installation” on page 5 of this manual.
9.2 Devices page
Use this page to detect, control and assign the devices in your local network.
• Detect button – Click the “Detect” button to scan the network for
connected devices. All detected devices will appear in the list.
• If you encounter problems when detecting connected devices,
please refer to “Networking basics and troubleshooting” on page 12.
Assigning devices to the available slots
You need to assign a device to a slot of the TC Icon software to control it.
Each instance of the TC Icon software can control up to eight dierent devices.
• Select a device from the list on the left side of the screen.
• Click one of the eight slots on the right side of the screen to assign the
selected device to this slot.
26 REVERB TWENTYFOUR Owner’s Manual