Manual

Topologies: Surround, Rows, Columns
When connecting Reverb TwentyFour to the physical inputs and outputs on the
Routing page, note that I/O numbers depend on the topology you have chosen.
Use the “Assignment” parameter on the Rev page to set the topology.
The topologies to choose from include:
• Surround, Rows, Columns.
• Layers, Planes.
Each of these topologies uses the I/O numbers dierently.
The currently selected topology is always shown on the Grid page.
Reverb TwentyFour and its factory presets are forgiving on speaker placement
– but presets expect all channels to produce the same SPL for a certain signal.
In case speakers are not aligned in level, osets should be applied on the
Trim page of the Reverb TwentyFour.
22.2 in/22.2 out Routing Preset
The 22.2 in/ 22.2 Routing preset settings and channel assignments are shown in
detail on page 39.
Using the Main and Grid pages
Load one of the factory presets into an Engine and go to its Main page. In this
example, we have chosen Engine E1, and preset "Symph. Hall Bottom."
The most important pages for quick edits are Main and Grid.
• On the Main page, use Groups to quickly balance levels and adjust timing, or
make A/B comparisons using the Mute and Zero functions. See “Main page”
(page 32).
• On the Grid page, use the graphic display to weigh reverb parameters using
an intuitive, visual approach – see “Using the Grid” below.
Please note that there are always two Groups of Channels. You assign Channels to
these Groups on the Setup page – see “Setup page” on page 34.
In all factory presets, channels 1 to 3 are assigned to Group 1, while all other
channels are assigned to Group 2.
Using the Grid
The Grid page provides a new approach to multichannel editing. The four
parameters shown below the Grid can quickly be varied across the algorithm’s
channels by osetting a dot from its center position.
• Select one of the four parameters shown below the Grid:
• Decay.
• Lo Decay.
• Hi Decay.
• Hi Cut.
• A green dot in the actual Grid will now represent the selected
parameter’s status.
• Set the selected parameter to a base value.
• Click the Reset button to center the dot and set the associated parameter to
the same value on all channels, or:
• Move the dot to obtain the variation required.
• Reverb TwentyFour provides decorrelated outputs, wether the
Grid parameters are set to the same setting or not.
30 REVERB TWENTYFOUR Owner’s Manual