Manual

In the Grid example below, the Grid has the Assignment parameter set to
Surround, and the Hi Cut parameter has been selected and moved towards the
center of the grid.
Grid setup
What happens when the dot in the Grid is moved o-center is dened in the
“Grid Setup” section of the Setup page. This Setup page example shows the
typical Groups for Surround Mode and Grid Setup used on most factory presets.
Decay Res. parameters
If you were to move the dot in the previous grid page towards the channel 8,
then with the Decay Res. parameter on the Setup page set to the “Default”
setting, the decay time of channel 8 would be much longer than the rest,
channel 5 and 7 somewhat longer, and channel 3 and 6 a bit longer.
For a more detailed explanation, see the following section.
A setting of 50 % for the Decay Res. parameter means that moving the dot
from the center towards a channel will prolong the previously set
Reverb Decay time by 50 %.
Focus parameters
The Decay Focus, Lo Decay Focus, Hi Decay Focus, and Hi Cut Focus parameters on
the Setup page determine how strongly neighboring channels are aected when
the dot is moved toward one channel.
• Narrow : There is only a limited inuence on the neighboring channel(s).
• Default: The neighbor channels are inuenced, and a bit of inuence is also
applied to their next neighbor.
• Wide: Similar to Default, but the eect on the respective channels is
more pronounced.
Focus may also be set to:
• “FB Only” (Front/Back only) or:
• “LR Only” (Left/Right only).
Those settings provide the same o-center adjustments to all channels in either
the Front/ Back or the Left/Right plane.
Resolution and Focus settings may be changed before or after adjusting the
Grid. For example, with the scenario shown above, if Decay Res. were changed
to -75%, the decay in channels 8, 5 and 7 (direct neighbors), 6 and 3 (neighbors’
neighbors) would become much shorter than the remaining channels.
31 REVERB TWENTYFOUR Owner’s Manual