Manual

Lo X Over
• Range: 20 to 500 Hz.
• Use the Lo X Over parameter to dene the crossover frequency from the
Low Frequency band to the Low Mid Frequency band.
Mid X Over
• Range: 200 Hz to 2 kHz.
• Use the Mid X Over parameter to dene the crossover frequency from the
Low Mid Frequency band to the High Mid Frequency band.
Hi X Over
• Range: 689 Hz to 20 kHz.
• Use the Hi X Over parameter to dene the crossover frequency from the
High Mid Frequency band to the High Frequency band.
15. Trim page
Level trims and Delay osets per output are available on the Trim page.
All parameters are additive to Level and Pre Delay settings on the Main page.
15.2.1 Delay Trim section
Delay Ch. 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8
• Range: 0 to 120 ms.
• Use the Delay Ch. 1 to Delay Ch. 8 parameters in the Delay Trim section to
delay each Reverb Channel by up to 120 milliseconds.
• These delay values are applied in addition to the Pre Delay Group 1 and 2
values set on the Main page – see “Pre Delay section” (page 32).
15.2.2 Output Trim section
Gain Ch. 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8
• Range: O, -115,5 to 0 dB.
• Use the Gain Ch. 1 to Gain Ch. 8 parameters in the Output Trim section to
attenuate each Reverb Channel.
• The Level reduction for each Channel as dened on this page is added to the
Out Level Group 1 and Out Level Group 2 values set on the Main page – see
“Levels section” (page 32).
36 REVERB TWENTYFOUR Owner’s Manual