Manual

OPERATION – REAR PANEL
16
3 – SPEAKER OUT
Use the SPEAKER OUT combo connector for connecting the
RH750 to your cabinet(s). You can use a speaker cable with
eitherSpeakonor¼”jacks.DoNOTuseinstrumentcables!
The RH750 can be used to drive any cabinet combination of up
to three RS cabinets, or any other cabinet combination with a 4
Ohm minimum load.
TM TM
GAIN
INPUT
BASS LO-MID
RH750
HI-MID TREBLE SPECTRACOMP TUBETONE MASTER
MUTE
CLASS-D
BASSAMPLIFIER
MEM3MEM2MEM1
HOLD
TOSTORE
ACTIVE/PASSIVE
PICK-UP
SHIFT
CENTER
PRESETLEVEL
TWEETERTONE
TM
TM TM
GAIN
INPUT
BASS LO-MID
RH750
HI-MID TREBLE SPECTRACOMP TUBETONE MASTER
MUTE
CLASS-D
BASSAMPLIFIER
MEM3MEM2MEM1
HOLD
TOSTORE
ACTIVE/PASSIVE
PICK-UP
SHIFT
CENTER
PRESETLEVEL
TWEETERTONE
TM
TM TM
GAIN
INPUT
BASS LO-MID
RH750
HI-MID TREBLE SPECTRACOMP TUBETONE MASTER
MUTE
CLASS-D
BASSAMPLIFIER
MEM3MEM2MEM1
HOLD
TOSTORE
ACTIVE/PASSIVE
PICK-UP
SHIFT
CENTER
PRESETLEVEL
TWEETERTONE
TM
TM TM
GAIN
INPUT
BASS LO-MID
RH750
HI-MID TREBLE SPECTRACOMP TUBETONE MASTER
MUTE
CLASS-D
BASSAMPLIFIER
MEM3MEM2MEM1
HOLD
TOSTORE
ACTIVE/PASSIVE
PICK-UP
SHIFT
CENTER
PRESETLEVEL
TWEETERTONE
TM
4 – DIGITAL OUT
UsetheDIGITALOUTtoconnectRH750’sdigitaloutputstage
directly to a digital audio device, such as a computer’s audio
interface. This way, you can record your bass sound straight
into Pro Tools, Logic or any other DAW application. The digital
output signal is in 96 kHz/24 Bit AES/EBU format. This ensures
the highest possible resolution and quality of your recorded bass
signal. To determine where in the signal chain the signal for
the digital output should be tapped, use the PRE/POST switch
located right beside the LINE DRIVER OUT jack on the RH750’s
rear panel. Your bass signal is present on both Left and Right
digital channel.
Setting up for recording:
In order to record straight from RH750’s digital output, follow
these steps:
– ConnectRH750’sDIGITALOUTtoyourDAW.
– SetyourDAWtosync/slaveto“externalclock”.
– HittherecordbuttoninyourDAWandstartplaying.
Digital Out - SPDIF Compatibility
While a simple XLR to RCA converter may suffice to allow
recording through an SPDIF interface, please note that AES/
EBU and SPDIF have different level and impedance specifications,
which in some cases can cause compatibility problems.
If you want to record with an analog signal instead,
you may also use the RH750’s balanced output
signal from the LINE DRIVER OUT jack.
5 – AUX IN Rehearse
Stereo Rehearsal Auxiliary Input.
Any signal present on the stereo AUX IN jacks is played back
through the PHONES output on the rear of the RH750. This
allows you to play along with a rehearsal track when checking
out new stuff or to practice to a beat or just a metronome click.
The included “Mini jack to RCA” cable allows you to use iPod®,
iPhone® or any other consumer playback device as a source for
rehearsing.