Quick Start Guide

24 25
DITTO MIC LOOPER DITTO MIC LOOPER
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE
INFORMATION
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 5270 Procyon Street,
Las Vegas NV 89118,
United States
Phone Number: [phone]
VOICETONE C1
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• • Reorient or relocate the receiving antenna.
• • Increase the separation between the equipment and receiver.
• • Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• • Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Important information:
Changes or modications to the equipment not expressly approved by
Music Tribe can void the user’s authority to use the equipment.
Operation Ambient Temperature up to 45°C.
TC Helicon
DITTO MIC LOOPER
(PL) Sterownica
(1) Loop level - Steruje głośnością zapętlonego dźwięku.
(2) Stop - Naciśnij, aby zatrzymać pętlę. Przytrzymaj przełącznik nożny,
aby usunąć pętlę.
(3) USB - Akceptuje kable mini-USB do aktualizacji
oprogramowania układowego.
(4) Loop - Naciśnij raz, aby nagrywać. Naciśnij ponownie, aby zatrzymać
nagrywanie i rozpocząć odtwarzanie w pętli. Powtórz dla dodatkowych
dogrywania. Przytrzymaj, aby cofnąć / ponowić ostatnie dogrywanie.
(5) Out - Podłącz do miksera lub głośnika zasilanego.
(6) Mic - Podłącz mikrofon.
(7) Power - Podłącz dołączony zasilacz 12 V /> = 400 mA.
Aby przełączyć się z domyślnej sekwencji Record / Play / Overdub na Record /
Overdub / Play, przytrzymaj oba przełączniki nożne podczas włączania.
Powtórz ten proces, aby przełączyć się z powrotem.
STOP / CLEAR
PRESS
PRESS AND
HOLD
STOP
CLEAR
LOOP
REC / PLAY / OVERDUB
UNDO / REDO
PRESS ONCE
PRESS AND
HOLD
PRESS AND
HOLD
RECORD PLAY OVERDUB
PRESS ONCE PRESS ONCE
UNDO REDO
LOOP
STOP