Owner's manual

Plug ‘n’ Go

If you own a TC-Helicon product shown as Auto-

compatible in the Compatibility Chart, and you’ve

connected both MIDI cables to the respective MIDI Ins

and Outs as detailed in the Quick Start section, then

HarmonyControl will operate in Auto mode and you’re

finished with the setup!

When first powered up, HarmonyControl sends out a

MIDI signal to see if any of the Auto-compatible units is

connected. If it gets the correct reply, HarmonyControl

will configure itself automatically to respond to preset

changes you make on your processor. You can then use

the preset change controls on your harmony processor

to switch between Scale and Chord based presets and

employ the sounds of their different harmony motion

in your songs.

The beauty of this is that once you’ve made the

connections, most of the time you can leave

HarmonyControl turned on and forget about it while

you run your harmony processor as you always have by

changing presets and turning its Harmony Mute on and

off when needed.

For the times when you prefer the sound of a fixed

key and scale, and your harmony processor is listed as

having the Scale Select feature in the Compatibility

Chart, you can use the Key footswitch function,

described on the next page.

Auto Mode