Reference Manual

Mix button/section
Play Acoustic – Reference manual (2014-07-16) 58
Press the MIX button to enter the Mix menu,
where various audio signal levels within your Play
Acoustic can be adjusted.
Mix page (1/2)
Harmony parameter
Use the Harmony parameter to control the over-
all level of all voice-generating effect blocks like
Harmony and Double.
Guitar Level parameter
Use the Guitar Level parameter to adjust the out-
put level of the guitar signal. This control is also
dependent on the Guitar input level, set in the
Setup menu. Make sure to set your input level
according to the instructions and use the Guitar
Level parameter to set your “overall guitar output
volume”.
Out Level parameter
Use the Out Level parameter to control the over-
all output level of your Play Acoustic.
Delay/Reverb level parameter
Use the Delay/Reverb level parameter to change
the level of Delay/Reverb effects across all pre-
sets.
This control is useful if you find yourself in a
performance environment that has a lot (or very
little) natural reverb and you’d like to “tune” your
sound to that room without having to manually
adjust all presets.
Headphone Level parameter
Use the Headphone Level parameter to adjust
the volume of the headphone output.
RoomSense parameter
Use the RoomSense parameter to control the
amount of ambient RoomSense sent to the
headphone mix. This parameter does NOT en-
able RoomSense to be sent to the main mix, as
this would cause feedback.
Aux Level parameter
The Aux Level parameter will only be shown if a
signal source is connected to the Aux connector.
Use the Aux Level parameter to adjust the level
of the signal received at the Aux input.
If you prefer to only hear the Aux input over your
headphones, go to the Setup/Output menu and
change “Aux to Main Out” to OFF.
If you would like the Aux input to “listen” for
chord information but not be heard at via the
Main Out or Headphone outputs, set the Aux
Level parameter to OFF.