User Manual

Option 2:
Upgrade Procedure Using MIDI to Update
Software
Requires #2 Philips screw driver
1. Unplug the power cable from the VoicePrism.
2. Remove the top of the VoicePrism by removing 7 screws.
3. Remove the back plate on the VoicePrism reserved for the
VoicePrismPlus expansion card by removing 4 screws.
4. Press the plastic standoff into the hole labeled MTH4 on the
main circuit board in the VoicePrism, as indicated in Figure 1.
5. The red stripe on the ribbon cable connected to the VoiceCraft
card indicates pin1. Align the connector on the ribbon cable with
J12 header making sure that pin 1 on the cable is oriented
correctly with pin 1 of J12.
6. CAREFULLY press the ribbon cable connector onto J12.
7. Position the VoiceCraft card so that the standoff is aligned with
the corresponding hole on the VoiceCraft Card.
8. Press the VoiceCraft card down so that the standoff presses into
the card.
9. Attach the plate of the VoiceCraft card to the back panel of the
VoicePrism using 4 screws removed earlier.
10. Put the top cover back on to the VoicePrism using 7 screws
removed earlier.
11. Plug the power cable into the VoicePrism and power up the unit.
12. Make note of the current version number (press the Utility
button and tab to the Version page).
13. Tab to the Upgrade page, one page to the right of Version.
14. Enter the upgrade code ‘H’, ‘V’, ‘K’.
15. Press soft knob 1 and select ‘EXECUTE’ from the popup menu.
16. A message box titled “ARE YOU SURE” will be displayed. If you
want to proceed select ‘YES’ and press soft knob 1.