User manual User Manual

1. MIC and LINE inputs -
Connect your microphone or
line level audio device’s output here. Only one should be
connected at a time. Hold the REVERB footswitch to set
gain when changing back and forth between MIC and
LINE ins.
2. GUITAR IN and THRU -
Connect a guitar to the
GUITAR IN to guide harmony and mix the guitar signal
into the main output. Connect the THRU to your guitar
amp and remove the guitar from the main mix output.
3. AUX In -
An audio signal received here can be mixed
into the main output or used to control harmony.
4. HEADPHONE Out -
The main output is mirrored
here to drive headphones. Adjust the headphone and
main output volume with the OUTPUT setting
controlled by turning the MIX knobs.
5. OUTPUTS -
The XLR and TRS (1/4”) produce the
same balanced audio output. Both can be used
simultaneously if required. Mono/Stereo configuration is
found in the I/O tab of the SETUP menu.
6. DIGITAL IN/OUT -
The S/PDIF-formatted DIGITAL
OUT is always active. Selecting this DIGITAL IN instead
Back Panel
12
3 5 6 7
1
2
4
8
9 10 11