User manual User Manual

DUCKING AMOUNT

This sets how much attenuation (gain reduction) is

applied to the reverb signal when a vocal is present. For

ducking to not be too obvious, a slight reduction of -6

is best.The DUCKING parameter must be set to ON for

this to have any effect.

DUCKING TIME

Ducking time sets how long it takes to ramp up the

reverb level at the end of vocal phrases.

LEAD to REV

Sets the amount of lead level sent into the Reverb block.

HARM to REV

Sets the amount of harmony level sent into the Reverb

block. Harmonies must be on to feed this send.

DEL to REV

This allows you to feed the reverb block with the

effected output of the delay block. The DELAY

footswitch must be on to feed this send.

LEAD LEVEL

Controls the lead (dry + Tone) voice level when the

individual effect is turned on with its respective

footswitch. This allows a unique wet/dry mix for

individual effects. When multiple effects are active, the

lowest LEAD LEVEL value will determine the value.

Note that the LEAD EFFECT SENDS parameter on the

PRESET tab must be set to PRE in order for any signal

to get to the effect block when LEAD LEVEL is set to

OFF.

The Edit Menu: REVERB Tab