Operation Manual

Introduction
VL3X – Reference manual (updated 2015-10-20) 29
Outputs
7
VL3X outputs overview
1. Guitar THRU: If you only need chord detec-
tion and want to pass your dry guitar signal
onto a different processor or record a dry gui-
tar track, use the THRU jack to pass your gui-
tar signal to your amp.
2. Monitor THRU: The Monitor THRU jack al-
lows you to receive an incoming Monitor IN
signal from a mixer and pass it on to another
monitor.
3. Headphone out: Connect headphones or
in-ear-monitors to the Headphone out and use
the Headphone Mix to set up your personal
mix.
4. Main Outputs: The Main Outputs carry Vo-
cals & Effects. If nothing is connected to the
Guitar outputs, Main outputs also carry Guitar
signals.
5. Guitar Outputs: The Guitar outputs carry the
Guitar signal. If only one output is connected,
guitar output is automatically in MONO. When
you connect the Guitar Out(s) to your amp(s),
guitar sounds will be removed from the Main
outputs.
6. MIDI Out: The MIDI Out jack sends MIDI Con-
trol Change messages (MIDI CCs) related to
footswitches and buttons pressed on VL3X. If
no CC is sent, there is likely no CC assigned
to that particular action.
Currently, Vocal & Guitar effects ON/OFF and
their respective levels are represented by MIDI
Control Change messages.
If you experience hum from your guitar amp or
PA, try pressing the GRND LIFT switch, located
between the Headphone out and the Left XLR
output.