Operation Manual

Introduction
VoiceLive 3 – Reference manual (updated 2015-10-20) 24
If it is a different Preset, enter Step management
and then use the Preset Up and Preset Down
footswitches to locate the Preset you would like
to add as a Step.
Adding a different Preset as a Step
► To accept changes, tap the Step footswitch.
► To delete the current step, tap the Layer
footswitch.
► To cancel, press the Home button.
The Step footswitch can be globally reassigned
to several different functions – such as Tap Tem-
po, HIT, Set Key, any Vocal or Guitar effect and
more. We have found that remapping Step to
enter/leave the Looper can be incredibly useful
in performance, when you need quick access in
and out.
For more information about Steps, see “Using
Steps”.
µMod footswitch
Tap the µMod footswitch to turn the
micro-modulation (µMod) effect on
or off.
The µMod block encompasses effects such as
Chorus, Flange, Detune and Rotor.
This effect can be configured and used sepa-
rately for the Vocal and Guitar layer. For more
information, see “Editing the Vocal Layer” and
“Editing the Guitar Layer”.
Delay footswitch
Tap the Delay footswitch to turn the
Delay effect (also known as echo) on
or off.
The Delay block encompasses effects such as ¼
Note, Multi-Tap and Ping Pong.
This effect can be configured and used sepa-
rately for the Vocal and Guitar layer. For more
information, see “Editing the Vocal Layer” and
“Editing the Guitar Layer”.
Tempo tapping
► To access tempo tapping, hold the Delay
footswitch.
► Tap the footswitch in time with your song.
A few taps are enough.
► When you are happy with the tempo, stop
tapping.