Operation Manual

The Alternate Tone Settings
Because the Tone feature is adaptive, you generally won’t
need to change it but there are additional settings that
may refine it for those who care to.
To access the Alternate Tone settings, hold the Tone
button until you see the Preset number display flash.You
can tap the Tone button to cycle through the numbered
choices shown below:
dd..
Default setting. Best for most situations.
11
Best if you have a very bright sounding PA.
Reduces brightness a little.
22
Adds “warmth” to the default setting for a slight
Bass boost at a narrow frequency.
33
Default plus increased compression. Caution: this
increases the likelihood of feedback.
Restoring Factory Presets And Settings
If at any time you want to get VoiceTone Create XT back
to its original presets and settings, follow this procedure.
1. Disconnect the power adapter from Create
2. Press and Hold the FX and Tweak buttons while
plugging the power adapter into Create XT.
3. Create XT will clear all the performance
information and return it to factory settings. Once
this is done (it only takes a couple seconds), Create
XT is ready to go.
External Mixing With Mono And Dry Outputs
The Dry output can be mixed externally with the mono
output so that the balance between your dry voice and
the effects can be adjusted by a sound engineer.
To use the Dry/Mono setup:
1. Connect each output to a separate mixer channel.
2. Set Create XT’s Mix control to 100% wet (fully
right).
3. Have your engineer raise or lower the mono effects
output channel on the mixer to suit your music.
For Advanced Users
24