Full Product Manual

PRE-INSTALLATION PROCEDURES
Before beginning your installation make sure you read the installation manual and insure all instructions and
safety guidelines are fully understood. Check that all component parts are accounted for. Locate the installation
area, identify the center line of the bay and mark the oor. Also mark the center of bay entrance door. Connect
these two points with a short chalk line in the area where lift will be located. Draw a second chalk line at 90° to
locate the positions of both lift columns. (Refer to lift dimensions on this page)
Keep this manual with lift at all times.
DO NO INSTALL LIFT ON ASPHALT OR
ANY OTHER SURFACE THAN A
CONCRETE FLOOR CONFORMING
TO THE MINIMUM REQUIREMENTS
DETAILED IN THIS MANUAL. DO NOT
INSTALL THIS LIFT ON CONCRETE
WITH SEAMS OR CRACKS OR DEFECT.
IF YOU HAVE ANY QUESTIONS AND
CONCERNS WITH THE LIFT LOCATION
SELECTED CONTACT YOUR LOCAL
ARCHITECT.
Recommended Bay Size
12FT x 24FT
Use safety protective clothing and protective wear when installing lift.
Installation Tools Required:
 25ft. Measuring tape
 Chalk line and chalk
 Heavy duty metal wire cutters
 3 ft. Crow bar
 Full set of metric wrenches and ratchet set
 Full set SAE wrenches and ratchet set
 Full set metric and SAE Allen keys
 1-1/8” Socket and Calibrated Torque Wrench
 Hammer
 Sledge hammer (for installing anchor bolts)
 Rubber mallet
 Phillip screwdrivers
 Flat blade screwdrivers
 Snap ring pliers
 (1) 10 ft. Step ladders
 (1) 4 ft. Level
 (1) rotary hammer drill with 3/4” diameter
masonry drill bit
 Lifting devices: Use proper lifting devices
such as cranes or a forklift.
 (8) 4” x 4” x 2FT wooden blocks
(use for unpacking)
 (2) Persons
 Gloves
 Air Compressor
List of items included in shipment:
 1 — Power Side Column
 3 — Non-Power Side Columns
 2 — Lifting Carriages
 4 — Ramps
 2 — Runways
 1 — Cylinder
 1 — Long Hydraulic Hose
 1 — Air Hose
 1 — Pneumatic Push Button
 1 — Power Unit
 2 — Chocks
 4 — Safety Latch Cover Assemblies
 1 — Hardware Kit
 1 — Full Attached Safety Label Kit
 1 — Installation Manual
 16 — Expansion Anchor Bolts 3/4” X 5 –1/2”
 1 — Installation Agreement signed by
purchaser and submitted to TCE for
Lift Valid Warranty.
A Qualied person should be consulted to address seismic loads and other local or state requirements.
A Qualied and Licensed Electrician should be consulted to install Electic Hydraulic Power Unit.
This car lift is designed for indoor installation, prohibiting outdoor installation of this lift.
Approved only for indoor installation. Outdoor Installation is not Recommended.
TORIN COMMERCIAL EQUIPMENT
16 REV 190425