Full Product Manual

POWER UNIT LOCATION
IMPORTANT NOTE
The Power Unit can be located at either “X” location shown below. It is important to locate the POWERSIDE
Runway (with Cylinder) on the SAME SIDE as the power unit location . Utility rails on the side of each Run-
way MUST be installed to the inside .
For the remainder of this instruction we will illustrate the Power Unit mounted at the DRIVER-SIDE (LEFT)
FRONT Column-TOP ILLUSTRATION. For Power Unit at right rear ,rotate lift 180 leaving Approach Ramps
and Front Tire Stops in original position .
Power Unit
Powerside Runway
Approach
Ramps
Power Unit
Powerside Runway
Approach
Ramps
TORIN COMMERCIAL EQUIPMENT
22 REV 190425