Full Product Manual

STEP1
(Column &Cross Tube Installation)
1. Place components on the floor according to
the floor plan layout. Pay attention to the power Unit location,
Locate and stand the column at the respective locations, DO NOT BOLT Columns down at this time, use
caution to prevent the Columns from failing over.
2. Insert the cross tube (making sure that Plastic
Side Block are still in position) and slide into the top of the
Columns, NOTE: The Sheave windows should be positioned inward and adjacent the Power Unit Column.
IMPORTANT NOTE!
Lower the cross tubes all the way down and rest on the floor, DO NOT install the safety ladders inside the
columns until the cross tubes are in position
Side blocks must
be in position
when installing
Single Sheave
window
SHEAVE WINDOWS SHOULD BE
FACING DOWN WHEN INSTALLED
Power unit mounting bracket
Power unit
mounting bracket
TORIN COMMERCIAL EQUIPMENT
23 REV 190425
Double Sheave
window