Full Product Manual

6. Install the Column TOP PLATES using the
M8x20mm HEX bolts, nuts & washers.Install the
nut on each Safety Ladder until 1/2” of threads are
exposed and the Ladder is raised at least 1/2” o of
the base of the Column.
NOTE:Raise the Ladder at least 1/2” o of the base
of the Column or damaged to the lift will occur. Be
sure to position the cable hole INWARD.
Secure Top Cap
with M8X20mm
Hex Head
Bolts&M8 Hex Nut
Ladder
Jam Nut
M16
Hex Nut
Cable Hole
Towards the
Inside
Column Top Plate
Ladder Top Nut M16
Nylock Nut
Jam Nut
Install the M16 nylock nuts and M16 washer on each
safety ladder above the top plate until approximately
one inch of threads are exposed.
Tighten the top nut on each safety ladder until one
inch of threads are exposed and the ladder is raised
at least 1/2” o of the base of the column.
WARNING
DO NOT raise the ladder more than one inch o
of the base of the column or damage to the lift will
result.
Step 5: Make sure to install bottom nut on safety
ladder stud threa before installing top plate. Install
top plate and secure top plate with the (4) mounting
bolts, nut and washers.
TORIN COMMERCIAL EQUIPMENT
24 REV 190425