Full Product Manual

SHIPPING DAMAGE CLAIMS
Once the equipment/product has been shipped, bill of sale passes to the Purchaser. Materials damaged in
shipment claims must be made by the Purchaser against the Freight Carrier at the time of shipment arrival.
Any freight damage must be noted on the freight bill before signing and reported to the freight carrier with a
freight claim established. Manufacturer is not responsible for freight claims. Identify the components and check
for shortages. If shortages are discovered, please contact the Distributor / Sales Representative in your area
for service. It is the customer’s responsibility to arrange for unloading of products shipped.
SHIPPING FREIGHT
This item is shipped via “truck freight” (common carrier or at-bed, not UPS). Truck freight companies do NOT
require their drivers to unload shipments. An additional “Lift Gate” fee will apply if the driver unloads the mer-
chandise. The shipping carrier will call and schedule delivery, at which time, you may request a “Lift Gate”
(provided the weight and dimensions of the product ts the criteria for lift gate service) and arrange payment
with the carrier for that service.
GENERAL SAFETY RULES
WARNING: Read and understand all instructions. Failure to follow all instructions listed below
may result in serious injury.
CAUTION: Do not allow persons to operate or assemble this product until they have read
this manual and have developed a thorough understanding of how the product works.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions or situations that could occur. It must be understood by the operator
that common sense and caution are factors that cannot be built into this product, but must be supplied by the
operator.
HAZARD DESCRIPTIONS
Use alertness and prudence in a hazardous situation; care; wariness.
Identify the hazard levels used in this manual with the following denitions and signal words:
IMPORTANT INFORMATION:
This lift is designed for indoor use only, and should not be installed in a pit or uneven surface.
Manufacturer recommends the oor on which the lift is to be installed must be 6” inch minimum thickness
concrete, with a minimum compressive strength of 3000 psi, and reinforced with steel bar, and a minimum
edge distance of 8 inches. (Contact your building architect for information before installing on Pre-stressed
concrete.)
The lift has specic electrical requirements as described in the Installation Instructions section of this manual.
This lift has a minimum ceiling height requirement as described in the Installation Instructions section of this
manual. Failure by the owner to provide the recommended shelter, mounting surface, electrical supply, and
ceiling height could result in unsatisfactory lift performance, property damage, or personal injury.
DANGER:
Immediate hazards which
will result in severe liability or
exposure to personal injury or
death.
WARNING:
Hazards or unsafe practices
which could result in severe
personal injury or death.
CAUTION:
Hazards or unsafe practices
which may result in person-
al injury, product or property
damage.
TORIN COMMERCIAL EQUIPMENT
3 REV 190425