Manualshelf

Full Product Manual

ManualsBrandsTCE ManualsAutomotiveStandard Lite-Duty Commercial Lift 4 Post Car Lift 9000 lbs. Load Capacity
31323334353637383940
Route the air line as shown below making sure to position the push button air valve with the INLET facing
towards the AIR SOURCE and the OUTLET facing the direction of the LIFT.
A lter/regulator/lubricator must be installed on air supply at lift.Failure to do so will void the warranty.Cut
the Provided 1/4” air line tubing with a sharp blade to lengths as required.Tubing must be cut square with
no burrs.
Note:To assemble air line tubing into tting,use rm,manual pressure to push tubing into the tting until it
bottoms out.
To remove air line tubing from thetting,hold push sleeve in (against tting)and,at the same time, pull out
on tubing.
Pay careful attention to keep air line clear of any pinch points.Improper assembly may result in safety lock
failure.
AIR PRESSURE SHOULD BE REGULATED TO 120 PSI MAX.
STEP 9
(Routing Air Lines)
TORIN COMMERCIAL EQUIPMENT
34 REV 190425