Full Product Manual
IMPORTANT POWER-UNIT INSTALLATION NOTES
DO NOT run power unit without oil. Damage to pump can occur.
The power unit must be kept dry. Damage to power unit caused by water or other liquids such
as detergents, acid etc., is not covered under warranty.
Improper electrical connection can damage motor and will not be covered under warranty.
Motor works with both 50Hz and 60Hz.
Use a separate breaker for each power unit.
Protect each circuit with time delay fuse or circuit breaker.
For 208-230 volt, single phase, manufacturer recommends using a 25-amp fuse.
INSTALLATION AND ADJUSTMENT.
DO NOT attempt to raise vehicle until a thorough operation check has been completed.
ALL WIRING MUST BE PERFORMED BY A CERTIFIED ELECTRICIAN ONLY.
SEE WIRING INSTRUCTIONS AFFIXED TO MOTOR FOR PROPER WIRING
INSTRUCTIONS.
3. Connect the Electrical hookup to the power unit; 208-240VAC Single Phase. Use wire capable of supporting
a 25-amp circuit. Longer Electrical Runs may require a larger diameter electrical wire.
WARNING: A certiî‚żed electrician must install any and all electrical wiring. Protect each circuit with a time delay
fuse or circuit breaker; 208v-240v single phase 50/60 Hz 25 amp. Requires AWG 10 Wire. Do not adjust power
unit pressure relief valve, any tampering will void warranty and may cause catastrophic failure. Failure to head
these warnings may result in injury or death.
DO NOT attempt to raise vehicle until a thorough operation check has been completed.
SEE WIRING INSTRUCTIONS AFFIXED TO MOTOR FOR PROPER
WIRING INSTRUCTIONS.
Single Phase Three Phase
M
N.O.RAISECOMMON
NOTE: MOTOR IS NOT PROTECTED AGAINST
TEMPERATURE OR CURRENT OVERLOADS.
NOTE: GROUND SCREW
IN WIRING BOX.
LOW
VOTACE
230 VOLT
30 SUPPLY
L1/
L2/
L3/
2
T1
T7
T2
T8
T3
T4
T5
T6
T9
1
43
65
M
TORIN COMMERCIAL EQUIPMENT
36 REV 190425