Full Product Manual

EXPANSION ANCHOR INSTALLATION INSTRUCTIONS ¾” X 5-1/2”
Anchor size is same as drill bit size ( .775” to .787“ )
Use a hammer drill with a Carbide tip, 3/4” diameter, solid drill bit. The bit tip diameter should be to
ANSI Standard B212.15-1994. The Simpson-Tie Strong Bolt 2 wedge anchor is used to resist static, wind and
seismic tension and concrete loads in cracked and uncracked concrete applications, with a
compressive strength of 3,000psi to 8,500psi. Supports Compliance with 2015, 2012, 2009, and 2006, 2003
International Building Code (IBC); and International Residential Code (IRC). The Strong-Bolt 2 wedge anchors
are torque-controlled, mechanical expansion anchors consisting of an anchor body, expansion clip, nut, and
washer.
Hammer Drill a hole to the same
nominal diameter as the
expansion anchor. The hole
depth must exceed the anchor
embedment at least ¼”. Use the
baseplate as a drilling template
to ensure proper anchor loca-
tions. (Drill completely through
the concrete oor in case
movement of the lift is required.)
Clean hole completely. Remove
dirt and dust with the use of a
shop vac. or an air compressor.
Assemble the at washer and
nut ush on the anchor bolt.
Drive the expansion anchor
into the hole using a hammer. If
shimming is required, make sure
to leave threads exposed for
proper shimming.
Tighten the nut to the
recommended installation
torque.
Installation complete.
Do not
cut or drill
through a
post
tension
cable!
(Locate any
post
tension
cables
before you
drill.)
Step
1
Step
2
Step
3
Step
4
Step
5
Do not disturb, bolt up, or apply
load to adhesive anchors prior to
the full cure of any adhesive.
Metal anchors and fasteners will
corrode and may lose load-car-
rying capacity when installed
in corrosive environments or
exposed to corrosive materials.
There are many environments
and materials which may cause
corrosion including ocean salt air,
re-retardants, fumes, fertilizers,
preservative-treated wood, dis-
similar metals, and other corrosive
elements. Finished Diameters
for Rotary and Rotary Hammer
Carbide Tipped Concrete Drills
per ANSI B212.15
TORIN COMMERCIAL EQUIPMENT
40 REV 190425