Full Product Manual

POST INSTALLATION PROCEDURE:
✓ Check boxes to verify work has been completed
Electric wired by a professional technician.
Power unit functioning properly.
With the in lift in the lowered position, check that the hydraulic fluid level is full. If needed, add oil as
described in the Installation Instruction section of this manual.
Check for “no” hydraulic leaks.
Check that all posts are square and plumb.
Lubricate posts with grease. Lubricate the four inside corners of the columns with heavy-duty bearing
grease
as needed.
Inspect lifting arms making sure they are functioning properly.
Visually inspect safeties for proper operation. Check all arm adjusting locks for proper operation.
Check lifting carriage gear restraints securely fastened.
Inspect all arms pins making sure they are properly secure.
Inspect that arm pads are in good condition.
Check that lift arms are level and synchronized.
Check equalizer cable tension, and adjust if necessary, see manual instructions.
Check all cables connections, bolts and pins to ensure proper mounting and torque.
Check safety latch synchronization: Safety latches should click at the same time. If necessary, adjust
equal
izing cables as described in the Installation Instruction section of this manual.
Lubricate all Cable Sheaves.
Check tightness of all bolts, nuts, pins, and hardware. Re-tighten as needed. See installation manual
torque specified ratings.
Inspect all anchors bolts and retighten if necessary. Re-torque as needed. See installation manual for
instruct
ions.
Inspects all roll pins and sheave pins are in proper alignment and secured.
Make a visual inspection of all moving parts and check for excessive signs of wear.
Check for no overhead obstructions.
If lift is equipped with an overhead stop bar, check for proper operation.
Test mercury switch operation.
Check all warning labels and power unit safety stickers are in good condition. Replace all caution,
warning or safety related decals on the lift if unable to read or missing. Reorder labels from manufacturer.
All components functioning properly.
All integral moving parts lubricated.
Working area clean.
Operation, maintenance and safety manuals in designated location.
TORIN COMMERCIAL EQUIPMENT
45 REV 190425