Full Product Manual

HOW TO OPERATE THE LIFT
1. Familiarize yourself with the lift before use.
2. Precautions and Safety should always be followed when operating this lift.
3. ONLY TRAINED and AUTHORIZED PERSONNEL should operate the lift. Do not allow customers or
unauthorized personnel to operate the lift or remain in the lift area during use.
4. Understand the vehicle lift operating controls before use. Make sure all operators have been trained and
review the OPERATOR TRAINING AND SAFE PRACTICES of this manual before using lift.
5. Always allow a minimum 2-second delay between motor starts. Failure to comply may cause switch and/
or motor to burnout. This could cause serious damage to the equipment and/or personal property. Power
unit must be wired by a qualified electrician. This power unit should be located at least 18 inches (460
mm) above the floor. Motor duty cycle is one full lifting operation 10 minutes.
6. This equipment has internal arcing or sparking parts which should not be exposed to flammable vapors.
7. Use only recommended ISO AW32 or AW46 hydraulic oils. Oil must be changed after the first week of
operation and once every 12 months or as needed. Add extra oil as needed.
8. See the instructions in the maintenance section of this manual how to add oil to the Power Unit.
9. Have a complete understanding of the carriage safety lock mechanisms.
✓ The “LOCKED position” will be used when raising the lift. This function should always work
automatically.
✓ The “UN-LOCKED position” will be used when lowering a lift or adjust
Note: DO NOT remove or tamper with the design of the locking assembly.
Failure to use locks as designed or forcing a lock to stay in the open position during use will be grounds
for immediate termination of this warranty and any manufacturer liabilities.
10. ALWAYS ensure the safeties are engaged before any attempt is made to work on or near the vehicle.
11. NEVER leave lift in elevated position unless the safeties are engaged.
12. NEVER operate the lift with any person or equipment below the vehicle.
13. NEVER exceed the rated lift capacity.
14. DO NOT PERMIT ELECTRIC MOTOR TO GET WET! Motor damage caused by dampness is not
covered under warranty.
15. ALWAYS position lifting, ramps, adapters and accessories properly out of the way before pulling the
vehicle into or out of the bay. Failure to do so could damage the vehicle and/or the lift.
16. After positioning the vehicle, set the emergency brake, make sure the ignition is off, the doors are
closed, overhead obstructions are cleared.
Warning:
17. Make sure vehicle is not front or rear heavy. The center of balance should be midway between adapters.
TORIN COMMERCIAL EQUIPMENT
51 REV 190425