Full Product Manual

TO RAISE THE LIFT,
26. Adjust the vehicle is that it is positioned with the center of gravity midway between the lift
27. Press the power “on” button.
28. A clicking sound will be heard as the lift raises. These are the crossbeam locks that will securely hold a
vehicle.
29. Once the desired height has been achieved slightly raise the crossbeams just above the last latch
position and slowly lower the load on the safety locks.
30. Verify that both Safety locks have been engaged before beginning work.
31. Use of jack stands or other load supporting devices will help in preventing load shifts.
32. Use additional lifting equipment or stands when removing or installing heavy vehicle components.
33. Make sure the vehicles center of gravity is always safe before raising vehicle. Any points of contact on
vehicle that are not in good contact with lift should always be double checked. Always make sure the vehicle
is secure before lifting using only your vehicle manufacturers’ recommended lifting points.
TO LOWER THE LIFT,
34. To lower the lift, first raise the lift to clear the safety latches, press the power “on” button,
then pull down the safety release handle to lower the lift. The carriages should now be in the free UN-
LOCKED position.
35. Simultaneously hold the Safety crossbeam Locks in the UN-LOCKED Position and press the
lowering control valve on the power unit.
36. Lower the lift slowly until reach the lowest retracted position.
TORIN COMMERCIAL EQUIPMENT
53 REV 190425