Full Product Manual

CUSTOMER DAILY MAINTENANCE INSPECTION RECORD DATE: _____________
✓ Check boxes to verify work has been completed
Power unit functioning properly.
With the lift in the lowered position, check that the hydraulic fluid level is full. If needed, add oil as
described in the Installation Instruction section of this manual.
Check for “no” hydraulic leaks
Check that all posts are square and plumb.
Lubricate posts with grease. Lubricate the four inside corners of the columns with heavy-duty bearing
grease as needed.
Inspect lifting arms making sure they are functioning properly.
Visually inspect safeties for proper operation. Check all arm adjusting locks for proper operation.
Check that all lifting carriage gear restraints are securely fastened, and that screws are tightened.
Inspect all arms pins making sure they are properly secure.
Inspect that arm pads are in good condition, replace if worn.
Check that lift arms are level and synchronized.
Check equalizer cable tension, and adjust if necessary, see manual instructions.
Check all cables connections, bolts and pins to ensure proper mounting and torque.
Inspect all cables for any damage, breaks, worn out, or corrosion. Replace cables if needed.
Check safety latch synchronization: Safety latches should click at the same time. If necessary, adjust
equalizing cables as described in the Installation Instruction section of this manual.
Lubricate all Cable Sheaves.
Check tightness of all bolts, nuts, pins, and hardware. Re-tighten as needed. See installation manual
torque specified ratings.
Inspect all anchors bolts and retighten if necessary. Re-torque as needed. See installation manual for
instructions.
Inspects all roll pins and sheave pins are in proper alignment and secured
Make a visual inspection of all moving parts and check for excessive signs of wear.
Check for no overhead obstructions
If lift is equipped with an overhead stop bar, check for proper operation.
Test mercury switch operation
Check all warning labels and power unit safety stickers are in good condition. Replace all caution,
warning or safety related decals on the lift if unable to read or missing. Reorder labels from manufacturer.
All components functioning properly
All integral moving parts lubricated
Working area clean
Operation, maintenance and safety manuals in designated location
Replace damaged, broken or wearing parts with lift manufacturer’s approved OEM parts only.
NOTES:_______________________________________________________________________________
______________________________________________________________________________________
______________________________________________________________________________________
PRINT COPY PAGES FOR DAILY RECORDS
DANGER: If anchor bolts are loose or any component of the lift is found to be defective, DO NOT USE THE LIFT.
• ALWAYS keep lift components clean.
• ALWAYS if oil leakage is observed, place lift out of service and contact Customer Service.
• ALWAYS contact a local service representative if electrical problems develop.
• ALWAYS keep bolts tight.
• ALWAYS replace ALL FAULTY PARTS before lift is put back into operation.
• Refer to ANSI/ALI ALOIM booklet for periodic inspection checklist and maintenance log sheet.
TORIN COMMERCIAL EQUIPMENT
54 REV 190425