User's Manual

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED

BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES

ACCORDING TO THE INSTRUCTIONS.

• CHARGERS

Home A.C./ Travel chargers will operate within the temperature

range of: 0°C (32°F) to 40°C (104°F).

The chargers designed for your mobile phone meet with the

standard for safety of information technology equipment and

office equipment use. Due to different applicable electrical

specifications, a charger you purchased in one jurisdiction may

not work in another jurisdiction. They should be used for this

purpose only.

Characteristics of power supply (depending on the country):

Travel charger: Input: 100-240 V, 50/60 Hz, 500 mA

Output: 5 V, 2A

Battery: Lithium 2610 mAh

Radio waves .....................

THIS MOBILE PHONE MEETS THE GOVERNMENT’S

REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.

Your mobile phone is a radio transmitter and receiver. It is

designed and manufactured not to exceed the emission limits for

exposure to radio-frequency (RF) energy. These limits are part

of comprehensive guidelines and establish permitted levels of

RF energy for the general population. The guidelines are based

on standards that were developed by independent scientific

organizations through periodic and thorough evaluation of

scientific studies. These guidelines include a substantial safety

margin designed to ensure the safety of all persons, regardless

of age and health.

The exposure standard for mobile phones employs a unit of

measurement known as the Specific Absorption Rate, or SAR.

The SAR limit set by public authorities such as the Federal

Communications Commission of the US Government (FCC), or

by Industry Canada, is 1.6 W/kg averaged over 1 gram of body

tissue. Tests for SAR are conducted using standard operating

positions with the mobile phone transmitting at its highest

certified power level in all tested frequency bands.

This device is complied with SAR for general population /

uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and had

been tested in accordance with the measurement methods and

procedures specified in IEEE1528.