User's Manual

5V2A
Before you get started
Make sure you read through all the instructions so that you can
access and enjoy the internet anytime anywhere.
This document is intended for HH41V, HH41CM, and HH41NH.
Where to put your router
To get the best signal, the ideal place for your device will be near
a window. Try a few different areas until you find the one with the
best signal.
Things that can affect your signal
strength
Concrete or wooden walls can weaken the transmission of wireless
signals. Electrical appliances that project strong electric or magnetic
fields such as microwave ovens, refrigerators and satellite antennas
can negatively affect your signal. Place your router away from such
appliances.
What's in the box:
Quick start guide
HH41 Power adapter Quick start guide
• Only use the Alcatel approved power adapter included with this
router.
• Unapproved chargers can be dangerous and damage the device.
Getting to know your device:
Power button
•Once connected to a power outlet, your Cat4 Router will automatically
power on.
•To power off your device, press and hold the power button for 3
seconds.
•To power on your device, press and hold the power button for 1
second.
WPS button
To enable WPS, press and hold the WPS button for 3 seconds. The
WiFi LED will start to flash blue. Then press the WPS button on the
device you wish to connect to within two minutes. Your Cat4 Router
will automatically assign your network settings to the device you
wish to connect to.
Reset button
Use a paperclip or blunt pin to gently press and hold the reset button
for 3 seconds, all LEDs will turn on, then off, and finally turn on again
once the reset is completed. You can also reset the device via the
Web-UI (refer to the Cat4 Router User Manual).
Power indicator
•Solid blue: The device is powered on.
•Off: The device is powered off.
WiFi indicator
•Solid blue: WiFi is enabled.
•Flashing blue: WPS connection is available.
•Off: WiFi is disabled.
TEL indicator
•Flashing blue: Phone is ringing.
•Solid blue: Phone is in call.
•Off: Phone is not in use.
Network indicator
•Solid green: Connected to 3G.
•Solid blue: Connected to 4G.
•Solid yellow: Connected to WAN.
•Solid red: No SIM available or the device is not registered to the
network.
•Flashing green: Registered to 3G.
•Flashing blue: Registered to 4G.
Signal indicator
•Solid blue: Signal strength ranges from 1-3 bars, with 3 being the
strongest.
•Off: No service / No signal / No SIM / Invalid SIM.
Getting started with your device:
Insert SIM
Follow the 3 steps in the illustration below.
1) Open the SIM slot cover.
2) Insert the SIM into the SIM slot.
3) Close the SIM slot cover.
Do not remove the SIM when your Cat4 Router is in use. Doing so
will affect the performance of your device, and data stored on the
SIM may be lost.
Connect the power adapter
Follow the illustration below to plug in the power adapter. Once
connected to a power outlet, your Cat4 Router will automatically
power on.
To prevent interference caused by radio signals, place the Cat4
Router at least one metre away from phones and other electrical
devices.
WPS button
Power button
TEL port
Signal indicator
Network
indicator
TEL
indicator
WiFi indicator
Power
indicator
Antennae port
LAN / WAN ports
Reset button