Product Info
During SAR testing, this is set to transmit at its highest certied
power level in all tested frequency bands, and placed in positions
that simulate RF exposure in usage near the body with the
separation of 10 mm, and the Limbs with the separation of 0 mm.
Although the SAR is determined at the highest certied power
level, the actual SAR level of the device while operating can be
well below the maximum value. This is because the device is
designed to operate at multiple power levels so as to use only the
power required to reach the network.
In general, the closer you are to a wireless base station antenna,
the lower the power output.
Additional information on SAR can be found on the Cellular
Telecommunications & Internet Association (CTIA) Web site:
http://www.ctia.org/
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for
help.