User's Manual

•Federal Communications Commission (FCC)

Declaration of Conformity

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

This device has been tested and found to comply with

the limits for a Class B digital , pursuant to Part 15 of

the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiated radio frequency energy and, if not installed

and used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a

particular installation If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more

of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and

receiver.

- Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician

for help.

FCC Caution:

Changes or modifications not expressly approved by the

party responsible for compliance could void the user‘s

authority to operate the equipment.

FCC RF Exposure Information (SAR):

This device is designed and manufactured not to exceed

the emission limits for exposure to radio frequency (RF)

energy set by the Federal Communications Commission of

the United States.