User's Manual

• BATTERY:
Before removing the battery from your phone, please make sure that the phone is switched off.
Observe the following precautions for battery use:
- Do not attempt to open the battery (due to the risk of toxic fumes and burns).
- Do not puncture, disassemble or cause a short-circuit in a battery,
- Do not burn or dispose of a used battery in the garbage or store it at temperatures above 60 °C.
Batteries must be disposed of in accordance with locally applicable environmental regulations. Only use the battery for the purpose for
which it was designed. Never use damaged batteries or those not recommended by T&A Mobile Phones Limited and/or its affiliates.
• CHARGERS:
Mains powered chargers will operate within the temperature range of: 0°C to 40°C.
The chargers designed for your cellphone meet with the standard for safety of information technology equipment and office equipment
use. They should be used for this purpose only.
Characteristics of power supply (depending on the country):
110 V charger (used in Mexico): 220 V charger:
Input: 100-127 V, 50/60 Hz, 0.30 A Input: 220-240 V, 50/60 Hz, 0.30 A
Output: 4.5 V, 350 mA Output: 4.5 V, 350 mA
Travel charger: Battery: Lithium 650 mAh
Input: 100-240 V, 50/60 Hz, 0.15 A
Output: 6.5 V, 350 mA
• RADIO WAVES:
THIS CELLPHONE MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your cellphone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to
radio-frequency (RF) energy. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the
general population. The guidelines are based on standards that were developed by independent scientific organizations through
periodic and thorough evaluation of scientific studies. These guidelines include a substantial safety margin designed to ensure the safety
of all persons, regardless of age and health.
The exposure standard for cellphones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set
by public authorities such as the Federal Communications Commission of the US Government (FCC), the Australian Communications
Authority (ACA) or by Industry Canada, is 1.6 W/kg averaged over 1 gram of body tissue. Tests for SAR are conducted using standard
operating positions with the cellphone transmitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the cellphone while operating can be well
below the maximum value. This is because the cellphone is designed to operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output of the
cellphone Before a cellphone model is available for sale to the public, compliance with national regulations and standards must be
shown.
7
CE5ELLE_UM_USA_28-10-05 28/10/05 14:18 Page 7