User's Manual

Getting started1.2

Set-up1.2.1

Removing or installing the back cover

Inserting or removing the SIM card

You must insert your SIM card to make phone calls. Please power off

your phone before inserting or removing the SIM card.

Place the SIM card with the chip facing downwards and slide it into its

housing. Make sure that it is correctly inserted. To remove the card,

press and slide it out.

For dual SIM models, both SIM1 and SIM2 can support 2G

and 3G networks, but when 3G SIM cards are inserted into

both SIM1 and SIM2 slot at the same time, only SIM1 will

support 3G network.

Installing or removing the battery

Please power off your phone before removing the battery.

Insert and click the battery into place, then close the cover.•

Unclip the cover, then remove the battery.•

Installing the microSD card

To install, please insert the external microSD card into the slot with

the gold contact facing down. To remove the external microSD card,

gently press and slide it out.

Charging the battery

Connect the battery charger to your phone and outlet respectively.

The charging status bar will not float if your battery is

extendly consumed. To reduce power consumption and

energy waste, when battery is fully charged, disconnect your

charger from the plug; switch off Wi-Fi, GPS, Bluetooth or

background-running applications when not in use; reduce

the backlight time, etc.

IP4759_5037E_Eng_USA_04_130925.indd 5-6

2013-9-25  6:33:49