User's Manual

48 DRAFT P440 Data Sheet / User Guide
Operating Temperature 23
o
C:
- On flat surface, receiving, light air
circulation
- On flat surface, receiving, no air
circulation
- In Time Domain standard
enclosure, receiving
32
o
C (9
o
over ambient)
41
o
C (18
o
over ambient)
47
o
C (24
o
over ambient)
Power &Temperature when Operating
as a Radar
Typical Power Consumption (board
temp 45
o
C, Vin= 5.0 V with state
transition times shown)
See Section 4.3.6 for details
- Active and scanning
- Active but not scanning
- IDLE, Standby_E, Standby_S
2.2 Watts
1.5 Watts
1.5 Watts (Enter: 1.2 ms, Exit: 1.2 ms)
Typical Power Consumption (board
temp 40
o
C, Vin= 48.0V with state
transition time shown)
See Section 4.3.6 for details
- Active and scanning
- Active but not scanning
- IDLE, Standby_E, Standby_S
3.2 Watts
2.2 Watts
2.2 Watts (Enter: 1.2 ms, Exit: 1.2 ms)
Operating Temperature 21
o
C:
- On flat surface, scanning, light air
circulation
- On flat surface, scanning, no air
circulation
- In Time Domain standard
enclosure, receiving
27
o
C (6
o
over ambient)
43
o
C (21
o
over ambient)
46
o
C (25
o
over ambient)
User Interfaces/Devices
USB:
USB 2.0 Client – Micro-B connector
Maximum rate: 480 Mbps
See Section 4.4.2 for more details
Serial:
3.3V TTL Serial UART (8, n, 1) 115.2kbps (typical)
921.6kbps (over short, ~15cm cable)
See Section 4.4.3 for more details
Ethernet:
10/100
See Section 4.4.5 for more details
SPI:
3.3V TTL levels
16Mbps maximum clock rate
See Section 4.4.4 for more details
CAN:
See Section 4.4.6 for details
GPIO available:
 3 Processor GPIO pin (3.3V)
 2 Processor GPIO pin (1.8V)
 8 FPGA GPIO pins (3.3V), 5 of which can be used
for SPI
 2 FPGA GPIO pins (1.8V)
See Section 4.5 for more details
On Board Temperature Sensor:
-40
o
C to 125
o
C, +/- 2.0
o
C