User manual

WARNING

Hazardous voltages exist at the outputs and the load connections. To protect personnel against

accidental contact with hazardous voltages, ensure that the load and its connections have no

accessible live parts. Ensure that the load wiring insulation rating is greater than or equal to the

maximum output voltage of the power supply.

Fig. 3-6: Load wires connection,8Vto 100V models.

150V to 600V Models

M10x25 screw (2 places)

Hex Nut (2 places)

Flat washer (2 places)

Spring washer (2 places)

Wire terminal lug (2 places)

Flat washer

(2 places)

Screws tightening torque: 290-310 Lb-inch.

Output Load Wires No Conductor Pretreatment: Phoenix Contact clamping parts are designed

so that all kinds of copper conductors can be clamped without pretreatment.

It is forbidden to solder the conductors. The solder tin yields and fractures under high pressure. The

result is increased contact resistance and an excessive temperature rise. In addition, corrosion

caused by pickling or fluxes has been observed on soldered conductor ends. Notch fractures at the

transition point from the rigid to the flexible conductor area are also possible.

CAUTION

Fig. 3-7: Bus-bars shield mounting,

8V to 40V models

Fig. 3-8: Bus-bars shield mounting,

60V to 100V models