User manual

CHAPTER 1 GENERAL INFORMATION

1.1 USER MANUAL CONTENT

1.2 INTRODUCTION

This user’s manual contains the operating instructions, installation instructions and specifications of

the Genesys 1500W and 750W power supply series. The instructions refer to the standard power

supplies, including the built-in RS232/485 serial communication. For information related to

operation with the optional IEEE programming, refer to User Manual for Power Supply IEEE

Programming Interface.

Genesys power supplies are wide output range, high performance switching power supplies. The

Genesys series is power factor corrected and operates from worldwide AC voltage range

continuously . Output voltage and current are continuously displayed and LED indicators show the

complete operating status of the power supply. The Front panel controls allow the user to set the

output parameters, the protection levels (Over-Voltage protection, Under-Voltage limit and

Foldback) and preview the settings. The rear panel includes the necessary connectors to control

and monitor the power supply operation by remote analog signals or by the built-in serial

communication (RS232/485). GPIB programming and Isolated-Analog programming/monitoring

are optional.

Model Voltage Current Model Voltage Current

range(V) range(A) range(V) range(A)

GEN6-100 0-6 0-100 GEN60-12.5 0-60 0-12.5

GEN6-200 0-6 0-200 GEN60-25 0-60 0-25

GEN8-90 0-8 0-90 GEN80-9.5 0-80 0-9.5

GEN8-180 0-8 0-180 GEN80-19 0-80 0-19

GEN12.5-60 0-12.5 0-60 GEN100-7.5 0-100 0-7.5

GEN12.5-120 0-12.5 0-120 GEN100-15 0-100 0-15

GEN20-38 0-20 0-38 GEN150-5 0-150 0-5

GEN20-76 0-20 0-76 GEN150-10 0-150 0-10

GEN30-25 0-30 0-25 GEN300-2.5 0-300 0-2.5

GEN30-50 0-30 0-50 GEN300-5 0-300 0-5

GEN40-19 0-40 0-19 GEN600-1.3 0-600 0-1.3

GEN40-38 0-40 0-38 GEN600-2.6 0-600 0-2.6

GEN50-30 0-50 0-30

Table1-1: Models covered by the manual

Constant Voltage / Constant Current with automatic crossover.

* Active Power Factor correction.

* Universal Input Voltage 85~265Vac, continuous operation.

* Embedded Microprocessor Controller.

* Built in RS232/485 Interface.

* Voltage & Current high resolution adjustment by digital encoders.

* High accuracy programming/readback-16 bit.

* Software Calibration (no internal trimmers / potentiometers).

* Last Setting Memory.

* Independent Remote ON/OFF (opto-isolated) and Remote Enable/Disable.

1.2.1 General description

1.2.2 Models covered by this manual

1.2.3 Features and options