User manual

3.4.2 Rack Mount Slides (optional):

Use rack mount slides: General Devices P/N: CC3001-00-S160 (ordering P/N: C-300-S-116-RH-

LH) or equivalent to install the unit in a standard 19” equipment rack. Refer to Fig. 3-1 for slides

assembly instructions. Use three #10-32x0.38"(max.) screws at each side. To prevent internal

damage, use the specified screw length only.

This power supply is fan cooled. The air intake is at the front panel and the exhaust is at the rear

panel. Upon installation allow cooling air to reach the front panel ventilation inlets. Allow minimum

10cm (4 Inch) of unrestricted air space at the front and the rear of the unit.

The power supply should be used in an area that the ambient temperature does not exceed +50 C.

The Genesys series can be operated from a nominal 100V to 240V, single phase, 47~63Hz. The

input voltage range and current required for each model is specified in Chapter 2. Ensure that under

heavy load, the AC voltage supplied to the power supply does not fall below the specifications

described in Chapter 2.

3.5 LOCATION, MOUNTING AND COOLING

3.6 AC SOURCE REQUIREMENTS

3.7 AC INPUT POWER CONNECTION

Ensure that the screws used to attach the slides to the unit do

not penetrate more than 6mm into the sides of the unit.

CAUTION

WARNING

Connection of this power supply to an AC power source

should be made by an electrician or other qualified personnel.

There is a potential shock hazard if the power supply chassis

(with cover in place) is not connected to an electrical safety

ground via the safety ground in theAC input connector

Fig.3-1: Rack-mount slides assembly

#10-32x0.38"(max.)

screws