Instructions

4.Connect the AC wires to the terminals of the input plug supplied with the unit. To connect the

wires, loosen the terminal screw, insert the stripped wire into the terminal and tighten the

screw securely (4.4-5.3 Lb-inch.). Refer to Fig. 3-3 for details. Pay attention to connect the

wires according to the polarity marking on the plug.

5. Connect the AC input plug to the AC input connector at the power supply rear panel. Fasten

the plug to the connector using the two screws at each side of the plug.

(Tightening torque:10.7-13.4Lb inch)

6. Route the wires inside the cover to prevent pinching. Fasten the cover to the unit using the

M3x8 Flat Head screws are provided. Refer to Fig.3-4 for details.

3.8 TURN-ON CHECKOUT PROCEDURE

3.8.1 General

3.8.2 Prior to Operation

The following procedure ensures that the power supply is operational and may be used as a basic

incoming inspection check. Refer to Fig.4-1 and Fig.4-2 for the location of the controls indicated in

the procedure.

1. Ensure that the power supply is configured to the default setting:

-AC On/Off switch at Off position.

-Dip switch : All positions at Down (”Off”) position.

-Sense connector : Configured to Local Sense as shown in Fig.3-5:

Fig.3-3: AC Input plug (3-Phase shown)

-For units equipped with IEEE option, ensure that the IEEE_En switch is in Up (default) position

(Refer to Fig.4-2, item 8 for location), if checkout is to be done in IEEE mode.

Fig.3-5: Sense connector default connection

1 Remote (+) sense

2 Local (+) sense

3 Not connected

4 Local (-) sense

5 Remote (-) sense

Plug P/N: MC 1.5/5-ST-3.81

(Phoenix)

Wire clamp screws

tightening torque: 10.7- 13.4 Lb-inch.

AC Input Plug :

Single Phase: P/N: PC6/3-STF-10,16

3-Phase: P/N: PC6/4-STF-10,16:

Protective Ground wire

AC Line wires

Fig.3-4: AC input cover and strain relief

Cover

Assembled Strain Relief

M3x8

Flat Head screws

(2 places)