Instructions

11
REGULATORY NOTICES
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
WARNING:
Modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment under FCC Rules.
CE NOTICE (European Union)
Marking by the CE Symbol indicates compliance to the Low Voltage Directive (2006/95/EC) of
the European Union. Such marking is indicative that the Z
+
series meet the following technical
standard: EN 61010-1 - ”Electrical Equipment For Measurement, Control and Laboratory Use;
Part 1: General Requirements.” A ”Declaration of Conformity” in accordance with the preceding
directives and standards has been made and is on file at our EU representative TDK-Lambda UK,
located at Kingsley Avenue, Ilfracombe, Devon EX34 8ES, UK.
SAFETY APPROVALS
UL 61010-1 and CSA-C22.2 No. 61010-1 - UL Listed, C-UL for Canada, IEC/EN 61010-1 - CB/TUV GS.
CE marking, when applied to the Z
+
series, indicates compliance with the Low Voltage Directive
2006/95/EC in that it complies with EN 61010-1.
OTHER
Z200, Z400, Z600, Z800 series are comply with the following Directives:
• RoHS2 Directive (2011/65/EU);
• WEEE Directive (2002/96/EC).
SAFETY INSTRUCTIONS
CAUTION:
The following safety precaution must be observed during all phases of operation, service and repair
of this equipment. Failure to comply with the safety precautions or warnings in this document violates
safety standards of design, manufacture and intended use of this equipment and may impair the
built-in protections within. TDK-Lambda shall not be liable for user’s failure to comply with these
requirements.
VORSICHT:
Die folgenden Sicherheitsvorschriften müssen vor Inbetriebnahme und in jedem Betriebszustand bei
Service oder Reparatur beachtet werden. Missachtung der Sicherheitsvorschriften und Warnhinweise
aus diesem Handbuch führen zur Verletzung der bestehenden Sicherheitsstandards. Bei Betrieb
des Gerätes außerhalb des bestimmungsgemäßen Einsatzes können die im Gerät integrierten
Schutzfunktionen beeinträchtigt werden. TDK-Lambda ist nicht haftbar für Schäden, die durch
Missachtung dieser Sicherheitsvorschriften entstehen können.