Instructions

Table 4-4: J3 connector terminals and functions

Fig.4-4: J3 connector terminals and functions

4.3.2 J3 Connector Terminal and Function

Control and monitoring signals are isolated from the

power supply output.

Connector Technical Information

• Connector type: IPL1-104-01-S-D-RA-K, SAMTEC

• Receptacle type: IPD1-04-D-K, SAMTEC

• Contact pins: CC79R-2024-01-L, SAMTEC

• Hand tool: CAT-HT-179-2024-11, SAMTEC

• Wire: AWG 20-24

Pin Signal name Function Section

1 Programmed Signal 1 General Purpose Open collector Port 1 5.7.3

2 PS_OK Output for indication of the power supply status. High level is OK. 5.7.4

3 Trigger Out Trigger output, positive true, pulse width: Min. 10usec 8.5.2

4 ILC Enable /Disable the power supply output by dry-contact (short/open). 5.7.2

5 Shut Off (SO) Input for shut off control of the power supply output. 5.7.1

6 Programmed Signal 2 General Purpose Open collector Port 2 5.7.3

7 IFC_COM Isolated interface, common.

8 Trigger In CMOS level input for triggering power supply output. Positive edge,

pulse width: Min. 10usec.

8.5.1