Data Sheet

ManualsBrandsTDK ManualsCoils & ChokesTDK B82787C0513H002 Inductor SMD B82787 0.051 mH 1000 mΩ 0.2 A 1 pc(s)

a~í~=pÜÉÉía~í~=pÜÉÉí

¤EPCOS AG 2016. Reproduction, publication and dissemination of this publication, enclosures hereto and the

information contained therein without EPCOS’ prior express consent is prohibited.

EPCOS AG is a TDK Group Company.

Data and signal line chokes

ACT45B common-mode chokes for CAN bus systems, EIA 1812

51 ... 100 μH, 150 ... 200 mA

Series/Type: ACT45B

Date: February 2016

Summary of content (7 pages)

PAGE 1
Data and signal line chokes ACT45B common-mode chokes for CAN bus systems, EIA 1812 51 ... 100 μH, 150 ... 200 mA Series/Type: ACT45B Date: February 2016 a~í~=pÜÉÉí ¤ EPCOS AG 2016. Reproduction, publication and dissemination of this publication, enclosures hereto and the information contained therein without EPCOS’ prior express consent is prohibited. EPCOS AG is a TDK Group Company.
PAGE 2
Data and signal line chokes ACT45B Common-mode chokes, EIA 1812 Rated voltage 50 V DC Rated inductance 51 ... 100 μH Rated current 150 ... 200 mA Construction ■ ■ ■ ■ Current-compensated double choke Ferrite I core Winding: enamel copper wire Winding welded to terminals Features ■ ■ ■ ■ Operating temperature range: –40 ...
PAGE 3
Data and signal line chokes ACT45B Common-mode chokes, EIA 1812 Dimensional drawing and pin configurationLayout recommendation Dimensions in mm Circuit diagram Taping and packing Blister tape Reel Dimensions in mm Please read Cautions and warnings and Important notes at the end of this document.
PAGE 4
Data and signal line chokes ACT45B Common-mode chokes, EIA 1812 Technical data and measuring conditions Rated voltage VR 50 V DC Max.
PAGE 5
Data and signal line chokes ACT45B Common-mode chokes, EIA 1812 Impedance versus frequency ACT45B-510-2P-TL003 ACT45B-101-2P-TL003 Please read Cautions and warnings and Important notes at the end of this document.
PAGE 6
Cautions and warnings ■ Please note the recommendations in our Inductors data book (latest edition) and in the data sheets. – Particular attention should be paid to the derating curves given there. – The soldering conditions should also be observed. Temperatures quoted in relation to wave soldering refer to the pin, not the housing.
PAGE 7
Important notes The following applies to all products named in this publication: 1. Some parts of this publication contain statements about the suitability of our products for certain areas of application. These statements are based on our knowledge of typical requirements that are often placed on our products in the areas of application concerned.